:::: MENU ::::

OSD TaskSequence TROUBLESHOOTING PROCEDURES

If you encounter an error during the imaging process, please note the error code generated by the Tssk Sequence Wizard. Please reboot the system and boot into the task sequence wizard using an available boot media or PXE function.

Once within the Task Sequence Wizard, select F8 to initiate the command prompt. Within the command prompt, please run the following commands depending on the error listed below:

 

For Microsoft Surfaces ONLY

  1. Enter the command “ipconfig /all” to verify that the machine has a network connection.
  2. Enter the command “time” to verify that the machine has the proper time set.
  3. Enter the command “date”, to verify that the machine has the proper date set. After verifying this information continue to the diskpart steps.

For Everything Else:

If you are not imaging a Surface Pro and receive a 0x8004005or 0x80070570 error, please use the Diskpart Steps that arebolded and listed below:

  1. Enter the command “diskpart”.
  2. Enter the command “list disk”, this will show a selection similar to the one listed below:

Disk ###  Status         Size         Free     DynGpt

——–  ————-      ——-       ——-    —      —

Disk 0    Online          238 GB     0 B        *(select the OS disk)

Disk 1    Online           28 GB      0 B

 

  1. Select the OS disk (Disk 0) with the following command: “select disk 0”.
  2. Once selected, enter the command “clean”.
  3. Once cleaned, enter the command “create partition primary”.
  4. Once the partition is created, select the partition with the command “Select partition 1”.
  5. Once selected, enter the command “active” to activate the partition.
  6. After selection, format the OS disk with the following command “format quick fs=ntfs”.
  7. After format, enter the command “assign” to assign a drive letter or mount point.
  8. After assigning the disk a mount point, enter the command “exit” to complete the processfollowed by a full reboot of the machine.

For an “0x8007005 or 0x80070070 error or an image where the primary drive isn’t imaged as C:”, please run the following diskpart steps:

  1. Enter the command “diskpart”.
  2. Enter the command “list disk”.
  3. Select the OS disk (Disk 0) with the following command: “select disk 0”.
  4. Once selected, enter the command “clean”.
  5. After cleaning the disk, enter the command “exit” to complete the process followed by a full reboot of the machine.

2 Comments

So, what do you think ?